3500L Double Cone Rotary Vacuum Dryer is being shipped
Oct 22,2024
View: 98
Leave a message
The container is a double cone rotary tank, with a jacket on the outside of the tank, and an insulation layer and an outer cover of the insulation layer on the outside of the tank jacket. The heat medium is introduced into the jacket by the hollow sleeve shaft and the condensed water is discharged. The heat contacts the wet material through the inner wall of the tank. The water vapor evaporated by the wet material after absorbing heat is pumped away by the vacuum pump through the vacuum exhaust pipe through the hollow sleeve shaft at the vacuum end of the tank. Since the tank is in a vacuum state, the boiling point of the volatiles is greatly reduced, and the rotation of the tank causes the material to continuously move up and down, inside and outside, so the drying speed of the material is accelerated, the drying efficiency is improved, and the purpose of uniform drying is achieved. Avoid the agglomeration and agglomeration of some materials in the static vacuum drying process.
Equipment features: The double cone rotary vacuum dryer is a dryer that integrates mixing and drying. The condenser, vacuum pump and dryer are matched to form a vacuum drying device (if the solvent does not need to be recovered, the condenser can be omitted). The internal structure of this machine is simple, easy to clean, the material can be completely discharged, and the operation is simple. It can reduce labor intensity and improve the working environment. At the same time, because the material rotates when the container itself rotates, but there is no accumulation of material on the wall, the heat transfer coefficient is high and the drying rate is large, which not only saves energy, but also makes the material dry evenly and fully with good quality.
Equipment application: This machine is suitable for vacuum drying and mixing of powdered and granular materials in the pharmaceutical, food, chemical and other industries. It is especially suitable for heat-sensitive materials that cannot withstand high temperatures, materials that need to recover solvents, materials containing toxic gases, materials that require extremely low residual volatile content, materials that are easily oxidized, materials that are hazardous, and materials that are easy to harden during static drying.
It can be widely used in drying in the pharmaceutical, chemical, food, dye and other industries. It meets the requirements of the pharmaceutical management specification "GMP".